43
Then open the
IP-GPRS Service
parameter group at the
Device Type
. Then the program
will load the related parameters.
At the
SERVER1
parameter fill the IP address of the IP-receiver and the
PORT1
value for the
port number.
Change the
IPPROTO
protocol’s format to
UDP
and the
SWPROTO
communication format
to
Enigma
which means a standard Contact ID protocol. (The
M2M
format means the modified
Contact ID (CID) protocol, which can only be used with the following IP receivers (as Enigma
II
®
, Enigma IP2
®
receivers) remote dispatcher software (as Alarmsys
®
and SIMS
®
software)).
If
you’ve changed
one of the listed parameter values, then the program will highlight the
changed value lines by
bold
. For sending the listed parameter values for the device (regarding
the
Selected
coloumn)
–
check the proper selection
–
push the
Write config
button at the
bottom of the screen. At the end of the parameter sending, the device is restarting by using
the new settings.
For the roaming settings, open the
Others
parameter group.
Where you can
Enable
the
ROAMING
function for the operation of mobile network roaming.
It is also necessary to enable the service on the mobile operator's side. If you will use it, you
