40
Fo further settings, please check the chapter 5.7.
5.2 Setup signaling to Enigma IP-Receiver / SIMS Cloud
®
When you want to make the device to transmit the incoming signals through cellular network
to the remote dispatcher center’s IP address, the following settings must be checked. If that
is necessary, you can change them.
In addition, the device is similarly able to signal into the SIMS Cloud management software.
GPRS transmitter settings
Load the factory default .CFG file by the
Browse
button.
Choose the
GPRS Settings
parameter group at the
Device Type
. Then the program will load
the related parameters.
Change the
GPRSEN
value to
Enable
status for the transmitting via the cellular network.
At the
SFUNCT
parameter you can define that the primary or secondary server IP address will
be the first in the signaling sequence.
The
BACKUP
parameter allows a GSM voice signaling to the centre - in case of cellular network
fall/outage. The GSM-relevant parameters must be also configured
–
e.g.
SYS1
.
(This should only be used in mobile network relay mode - not in GSM relay mode!)
