2
Watkiss DigiVAC Service Manual - Issue 2 - 29/11/04
Overview
•
Introduction
1.1.3 Orientation
Where procedures refer to the R/H (right hand) or L/H (left hand) side of the
machine, this is always as viewed from the front, feed bin end of the machine.
Figure 1:1
1.1.4 Test Paper
Ensure that a supply of paper is available for testing purposes. This should ide-
ally be A4 and A3 (or 8½ x 11” and 11 x 17”). Check that the paper is cut
square and to the correct size before making any changes to the machine.
1.1.5 Metric and Imperial measurements
In most cases metric measurements and specifications are used in this manual.
A conversion chart is included in this manual (see Section 9.1). The DigiVAC
control panels can be set to use either metric or imperial measurements, refer
to the relevant operating manual.
1.1.6 Moving the DigiVAC
Over small distances, the DigiVAC can be moved by raising the jacking screw
and pushing it on its integral wheels. For longer distances, the DigiVAC is
supplied with transport wheels which should be used (see Section 7.2).
Figure 1:2
Front of the DigiVAC
