50
Watkiss DigiVAC Service Manual - Issue 2 - 29/11/04
Service Procedures
•
X-Jogger
Selecting the Jogger Function:
DigiVAC standard: Press
@
to offset stack each set. Press
(
to offset each
batch of sets.
: Touch
BASIC
followed by
OSCILLATE
to offset stack each set.
Touch
BATCH
followed by
OSCILLATE
to offset each batch of sets.
Tray Full Sensor:
A tray full sensor controls the collator when the tray is full.
An error message will be displayed on the control panel.
3.9.1 X-Jogger General Inspection
Due to the nature of its operation the D-XJG requires periodic inspection to
ensure that all earth straps and fasteners are secure and have not vibrated loose.
A nut lock compound should be used on fasteners which repeatedly loosen.
3.9.2 X-Jogger Sidelay/Endlay Screw Adjustment/Cleaning
If the ball bearings that run in the adjustment screws become loose, the move-
ment of the sidelays and endlay will become loose and inaccurate and will self
adjust due to the jogger vibration.
Procedure - Sidelays
1. Disconnect the D-XJG power and data cables from the DigiVAC.
2. The M8 grub screw ‘A’ (see Figure 3:39) should be tightened to remove
any excess play in the sidelay movement. Do not over tighten the screw as
this will cause the mechanism to bind and wear prematurely.
Figure 3:39 Sidelay Screw Adjustment and Cleaning
3. Repeat the procedure for the other sidelay if needed.
PARTS REQUIRED
TOOLS REQUIRED
None
2.5mm Allen Key
4mm Allen Key
7mm Spanner
Thread Locking Compound
A
