104
Watkiss DigiVAC Service Manual - Issue 2 - 29/11/04
Electronics & Software
•
Software - GUI Control Panel
2. Press
s
,
l
or
d
to download the application software to the Download
Cache.
3. If required, check software versions with the
c
,
f
or
i
commands.
4. Press
p
to program the Flash Memory from the Download Cache.
5. Press
z
to reboot the DigiVAC.
Figure 4:32 Summary of the Boot Firmware Commands.
4.4.9 Error Bleeps
The boot firmware uses various error codes to identify problems. The error
codes may be played one after another, should multiple errors occur.
• = short bleep
— = long bleep
~ =
pause
— ~ • • • •
Normal - startup countdown
• •
Flash memory successfully programmed
— — —
The program in flash memory is not recognised
— • • •
The program on the SFM card is not recognised
— — •
The decompression of the S/W has failed
— — • •
Programming from the SFM card has failed
— •
There is a problem with the machine settings files (which
store information about network settings, etc.) or the device
that stores them
• • •
There is a problem with the job memory files or the device
that stores them
Type
l
to load
from SFM Card
Type
d
to load
from Ethernet
Type
s
to load
from RS232
RS232 connection
Type
c
to see version of
software in download cache,
type
r
to run uncompressed
software from download cache
GUI CPU
DOWNLOAD
CACHE
GUI CPU
FLASH
MEMORY
Type
i
to see which software
version is on the SFM Card
Ethernet connection
Type
p
to program
Flash Memory from
Download cache
Type
f
to see version of
software in flash memory,
type
z
to exit boot firmware
TFTP
xmodem
