14
Watkiss DigiVAC Service Manual - Issue 2 - 29/11/04
Service Procedures
•
General Service Procedures
3.1.2 Removing the Rear Conveyor Assembly
For many service procedures it is necessary to remove the rear conveyor
assembly.
Procedure
1. Push conveyor to the left against the spring pressure
2. Pull the right edge of the conveyor outwards
3. Ease the conveyor assembly downwards and lift it clear of the collator
Figure 3:1 Removing the rear conveyor assembly
After refitting the rear conveyor, make sure all the conveyor belts are correctly
aligned.
3.1.3 Removing the Rear Deflector Plates
For many service procedures it is necessary to remove the rear deflector plates.
Figure 3:2 Rear Deflector Plates
There are two possible methods of removing a rear deflector plate:
• Remove both M5 button head screws and lift the plate clear.
• Remove the M5 button head screw on the R/H side of the machine (this
is the left hand screw when viewed from the rear of the machine). Then
loosen the L/H screw and the plate can be eased out.
1
2
3
1. Push conveyor to the left against
the spring pressure
2. Pull the right edge of the con-
veyor outwards
3. Ease the conveyor assembly
downwards and lift it clear of the
collator
Deflector Plates
Conveyor Wheels
