VEM VEMoDRIVE VSI 2.0 HD, Instruction Manual

Page: 60 / 244

58 Main Features CG Drives & Automation, 01-5326-01r3b
Fig. 62 Input and output status for edge-control
7.3 Performing an
Identification Run
To get the optimum performance out of your AC drive/
motor combination, the AC drive must measure the
electrical parameters (resistance of stator winding, etc.) of
the connected motor. See menu [229] “Motor ID-Run”.
It is recommended that the extended ID run is used before
the motor is installed in the application.
If this is not possible, the short ID run should be used.
7.4 Using the Control Panel
Memory
Data can be copied from the AC drive to the memory in the
control panel and vice versa. To copy all data (including
parameter set A-D and motor data) from the AC drive to the
control panel, select Copy to CP[234], Copy to CP.
To copy data from the control panel to the AC drive, enter
the menu [235], Load from CP and select what you want to
copy.
The memory in the control panel is useful in applications
with AC drives without a control panel and in applications
where several AC drives have the same setup. It can also be
used for temporary storage of settings. Use a control panel to
upload the settings from one AC drive and then move the
control panel to another AC drive and download the set-
tings.
Fig. 63 Copy and load parameters between AC drive and
control panel
WARNING!
During the extended ID RUN, the motor shaft
will rotate. Take safety measures to avoid
unforeseen dangerous situations.
(06-F94new_1)
INPUTS
ENABLE
STOP
RUN R
RUN L
OUTPUT
STATUS
Right rotation
Left rotation
Standstill
NOTE: Load from and copy to the AC drive is only
possible when the AC drive is in stop mode.
AC drive
9(0R'ULYH 96, 9(0 U