Suzuki 2009 LT-A500XP, Service Manual

Page: 504 / 624

5A-20 Automatic Transmission:
• After installed the clutch housing, check if the clutch
housing rotates smoothly.
Clutch Related Parts Inspection
B931H25106013
Refer to “Clutch Cover Disassembly and Assembly
(Page 5A-18)”.
Clutch Shoe
Inspect the boss and centrifugal weight fulcrum sections
for looseness, damage and operation.
Inspect the clutch shoe for damage and fouling with oil
on the surface.
If any defects are found, replace the clutch shoe
assembly with a new one.
Measure the thickness of the clutch shoe at the center
position. If the thickness is less than the service limit,
replace the clutch shoe assembly with a new one.
Clutch shoe thickness
Service limit: No groove at any part
Clutch housing
Inspect the clutch housing for any abnormal surface
damage. Measure the inside diameter of the clutch
housing. If the measurement exceeds the service limit,
replace the clutch housing with a new one.
Clutch housing I.D.
Service limit: 140.5 mm (5.53 in)
Left Clutch Housing Bearing
Rotate the inner race by finger to inspect for abnormal
play, noise and smooth rotation. If there is anything
unusual, replace the bearing with a new one.
One Way Clutch
Install the one way clutch (1) onto the proper direction as
shown.
NOTE
When Installing the one way clutch (1) onto
the clutch housing (2), make sure that the
“OUTSIDE” mark “A” in the one way clutch
faces to the clutch housing.
I931H1510081-01
I831G1510084-01
I931H1510104-01
“a”: play
I831G1510086-01
“ a ”
“ a ”
I831G1510087-01
1
2
“A”
I931H1510082-01