Suzuki 2009 LT-A500XP, Service Manual

Page: 471 / 624

Rear Brakes: 4C-5
12) Remove the side plate stopper (13).
13) Remove the side plate (14), pins (15) and springs
(16).
14) Separate the friction plates (17) and separator plates
(18).
Assembly
CAUTION
!
The removed oil seal, bearing and snap ring
must be replaced with new ones.
• Install the rear brake in the reverse order of
disassembly. Pay attention to the following points:
• Assemble the rear brake plates as shown in the
figure.
CAUTION
!
Replace the removed side plate stopper (4)
with a new one.
• Apply final gear oil to the bearing (5) before installing
it.
• Install the bearing with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
NOTE
The stamped mark of bearing faces outside.
• Install the snap ring (6).
• Install the oil seals (7) and (8) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
13
14
16
15
I831G1430043-03
17
18
I931H1430015-02
1. Separator plate 4. Side plate stopper
2. Friction plate “A”: Direction of out side
3. Side plate
“A”
3
3
2
1
4
4
I831G1430022-04
(A)
5
6
I831G1430023-03
(A)
7
8
I831G1430024-05