Suzuki 2009 LT-A500XP, Service Manual

Page: 435 / 624

Propeller Shafts: 3D-23
2) Insert the universal joint to the bearing and check the
play by turning the universal joint, as shown in the
figure. If excessive play is found, replace the
bearings and universal joint as a set.
Rear Propeller Shaft Spring
Inspect the rear propeller shaft spring for wear or
damage. If any defects are found, replace it with a new
one.
Specifications
Service Data
B931H23407001
Drive Train
Unit: mm (in)
Tightening Torque Specifications
B931H23407002
NOTE
The specified tightening torque is described in the following.
“Rear Output Shaft Components (Page 3D-6)”
“Front Propeller Shaft Components (Page 3D-15)”
“Rear Propeller Shaft Components (Page 3D-18)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List: in Section 0C” .
I831G1340094-01
I931H1340098-01
Item Standard Limit
Front/Rear output shaft bevel gear
backlash
0.03 – 0.15 (0.001 – 0.006) —
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lbf-ft
Rear output shaft drive bevel gear nut 100 10.0 72.5
)
(Page 3D-8)
Rear output shaft driven gear nut 100 10.0 72.5
)
(Page 3D-10)
Rear output shaft nut
100 10.0 72.5
)
(Page 3D-11) /
)
(Page 3D-20)
Front propeller shaft boot clamp screw 1.3 0.13 1.0
)
(Page 3D-17)
Rear propeller shaft boot clamp screw 2 0.2 1.5
)
(Page 3D-21)