Propeller Shafts: 3D-11
• With the rear output shaft held immovable with a vise,
tighten the rear output shaft nut.
CAUTION
!
The removed rear output shaft nut must be
replaced with a new one.
Tightening torque
Rear output shaft nut (b): 100 N·m (10.0 kgf-m,
72.5 lbf-ft)
• After the backlash and tooth contact have been
checked or adjusted, lock the rear output shaft nut
with a center punch. Refer to “Driven / Drive Bevel
Gear Shim Inspection and Adjustment (Page 3D-12)”.
• Apply grease to the bearings and their lip of dust seal.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the universal joint (8) and yoke (9).
• Install the bearings (10) by tapping with the special
tool.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
• Install the circlips to the universal joint.
CAUTION
!
The removed circlips must be replaced with
new ones.
• After reassembling the universal joint, check the joint
movement smoothly. If a large resistance is felt to
movement, tap the bearing with a plastic mallet lightly.
(b)
I931H1340047-01
I931H1340048-01
I931H1340049-01
(A)
10
9
8
10
I931H1340050-01
I931H1340051-01
I931H1340052-04
Summary of Contents for 2009 LT-A500XP
