Charging System: 1J-8
Regulator / Rectifier Inspection
B931H21A06005
Inspect the regulator/rectifier in the following procedures:
1) Turn the ignition switch OFF.
2) Remove the rear fender. Refer to
“Rear Side Exterior Parts Removal and Installation: in Section 9D”
.
3) Disconnect the regulator/rectifier coupler (1) and remove the regulator/rectifier (2).
4) Measure the voltage between the terminals using the multi-circuit tester as indicated in the following table. If the
voltage is not within the specified value, replace the regulator/rectifier with a new one.
NOTE
If the tester reads 1.4 V and below when the tester probes are not connected, replace its battery.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test (
)
Unit: V
5) Connect the regulator/rectifier coupler and reinstall the removed parts.
1
2
I931H11A0023-01
“C”
“D”
“E”
“F”
“A”
“B”
I931H11A0024-01
“A”
“B”
“C”
“D”
“E”
“F”
(–) probe of
tester to:
“A”
—
*
0.4 – 1.2
0.3 – 0.7
0.3 – 0.7
0.3 – 0.7
“B”
*
—
*
*
*
*
“C”
*
*
—
*
*
*
“D”
*
*
0.3 – 0.7
—
*
*
“E”
*
*
0.3 – 0.7
*
—
*
“F”
*
*
0.3 – 0.7
*
*
—
*1.4 V and more (tester’s battery voltage)
Summary of Contents for 2009 LT-A500XP
