Suzuki 2009 LT-A500XP, Service Manual

Page: 356 / 624

3A-7 Drive Chain / Drive Train / Drive Shaft:
Installation
Install the rear drive shaft in the reverse order of
removal. Pay attention to the following points:
• Install a new circlip (1) into the groove of drive shaft
spline.
CAUTION
!
The removed circlip must be replaced with a
new one.
• Apply grease to the spline of the rear drive shafts.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply grease to the lip of the oil seal and install the
rear drive shafts to the rear final gear case.
: Grease 99000–25160 (Water resistance
grease or equivalent)
CAUTION
!
Be careful not to damage the front drive case
oil seal.
NOTE
After installing both drive shafts, make sure
the circlips (1) is seated properly by pulling
both inboard joints lightly.
Rear Drive Shaft Disassembly and Assembly
B931H23106007
Refer to “Rear Drive Shaft Assembly Removal and
Installation (Page 3A-6)”.
Rear drive shaft disassembly and assembly are the
same manner of front drive shaft disassembly and
assembly except for the position of inner boot bond.
Rear Drive Shaft Inspection
B931H23106008
Refer to “Rear Drive Shaft Assembly Removal and
Installation (Page 3A-6)”.
Rear drive shaft inspection as the same manner of front
drive shaft.
1
I931H1310011-03
“D”: Right side “F”: Rotation direction
“E”: Left side “a”: 166 mm (6.5 in)
A
VIEW A
“F”
“D”
“E”
“F”
“ a ”
I931H1310015-02