Suzuki 2009 LT-A500XP, Service Manual

Page: 433 / 624

Propeller Shafts: 3D-21
6) Install the yoke (4).
7) Install the bearings (5) by tapping with the special
tool.
Special tool
(A): 09913–70210 (Bearing installer set (10
– 75))
8) Install the circlips (6) to the universal joint.
9) Install the rear propeller shaft boot (7) and tighten
the clamp screw (8) to the specified torque.
Tightening torque
Rear propeller shaft boot clamp screw (b): 2
N·m (0.2 kgf-m, 1.5 lbf-ft)
10) Install the O-ring (9) to the rear propeller shaft.
11) Fit the rear propeller shaft joint boot (10) to the rear
propeller shaft groove.
12) Apply resistance grease (approx. 4 grams) to the
splines of the rear propeller shaft.
: Grease 99000–25160 (Water resistance
grease or equivalent)
13) Install the rear propeller shaft (11).
14) Apply grease (approx. 4 grams) to the spline of rear
propeller shaft and propeller shaft spring (12).
: Grease 99000–25160 (Water resistance
grease or equivalent)
15) Install the rear propeller shaft spring (12).
5
5
(A)
4
I931H1340086-02
6
6
I931H1340087-02
7
(b)
8
I931H1340089-03
9
I931H1340088-02
10
I931H1340090-02
12
11
I931H1340091-02