Suzuki 2009 LT-A500XP, Service Manual

Page: 158 / 624

1D-10 Engine Mechanical:
3) Disconnect the fuel injector coupler (2) and TP/IAP/
IAT sensor coupler (3).
4) Disconnect the ISC valve coupler (4).
5) Remove the throttle cable cover (5).
6) Disconnect the throttle cable (6).
CAUTION
!
After disconnecting the throttle cables, do
not snap the throttle valve from full open to
full close. It may cause damage to the throttle
valve and throttle body.
7) Loosen the throttle body clamp screw and remove
the throttle body assembly.
Installation
NOTE
When replacing the throttle body, turn ON the
ignition switch and turn OFF again.
Install the throttle body in the reverse order of removal.
Pay attention to the following points:
• Install the throttle body.
NOTE
When installing the throttle body, fit the
concave part “A” of the intake pipe onto the
convex part “B” of the throttle body.
• Tighten the throttle body clamp screws. Refer to
“Throttle Body Construction (Page 1D-9)”.
4
3
2
I931H1140014-02
5
I931H1140015-01
6
I931H1140016-01
I931H1140017-01
“A”
“B”
I931H1140018-01
I931H1140019-01