Subaru impreza 2017, Owner'S Manual

Page: 129 / 786

a
b
a>b
BLOCK
AND
I
OP
Extract second
harmonic current
component
Extract
fundamental
current component
X
2ndHarmStab
a
b
a>b
a
b
a>b
0.07*IBase
IEC13000015-4-en.vsdx
UseStartValue
IN1>
IN2>
IN3>
IN4>
a
b
a>b
t
t=70ms
OR
AND
BlkParTransf=On
q
-1
OR 2ndH_BLOCK_Int
q
-1
= unit delay
IEC13000015 V4 EN-US
Figure 46: Simplified logic diagram for 2nd harmonic blocking feature and Block for Parallel Transformers
feature
6.4.7.10 Switch on to fault feature
M13941-211 v5
Integrated in the four step residual overcurrent protection are the switch on to fault
logic (SOTF) and the under-time logic. The setting parameter
SOTF is set to
activate SOTF, the under-time logic or both. When the circuit breaker is closing
there is a risk to close it onto a permanent fault, for example during an
autoreclosing sequence. The SOTF logic will enable fast fault clearance during
such situations. The time during which SOTF and under-time logics will be active
after activation is defined by the setting parameter
t4U .
The SOTF logic uses the start signal from step 2 or step 3 for its operation, selected
by setting parameter
StepForSOTF . The setting parameter ActivationSOTF can be
set for activation of CB position open change, CB position closed change or CB
close command. In case of a residual current start from step 2 or 3 (dependent on
1MRK 505 384-UEN A
Section 6
Current protection
Breaker protection REQ650 2.2 IEC 123
Technical manual