Subaru impreza 2017, Owner'S Manual

Page: 351 / 786

10.3.5 Settings
PID-6513-SETTINGS v4
Table 208: TMAGAPC Group settings (basic)
Name Values (Range) Unit Step Default Description
Operation Off
On
- - Off Operation Off / On
PulseTime 0.050 - 60.000 s 0.001 0.150 Output pulse time
OnDelay 0.000 - 60.000 s 0.001 0.000 Output on delay time
OffDelay 0.000 - 60.000 s 0.001 0.000 Output off delay time
ModeOutput1 Steady
Pulsed
- - Steady Mode for output ,1 steady or pulsed
ModeOutput2 Steady
Pulsed
- - Steady Mode for output 2, steady or pulsed
ModeOutput3 Steady
Pulsed
- - Steady Mode for output 3, steady or pulsed
10.3.6 Operation principle
SEMOD52537-5 v8
The trip matrix logic (TMAGAPC) block is provided with 32 input signals and 3
output signals. The function block incorporates internal logic OR gates in order to
provide grouping of connected input signals to the three output signals from the
function block.
Internal built-in OR logic is made in accordance with the following three rules:
1. when any one of first 16 inputs signals (INPUT1 to INPUT16) has logical
value 1 the first output signal (OUTPUT1) will get logical value 1.
2. when any one of second 16 inputs signals (INPUT17 to INPUT32) has logical
value 1 the second output signal (OUTPUT2) will get logical value 1.
3. when any one of all 32 input signals (INPUT1 to INPUT32) has logical value
1 the third output signal (OUTPUT3) will get logical value 1.
By use of the settings ModeOutput1 , ModeOutput2 , ModeOutput3 , PulseTime ,
OnDelay and OffDelay the behavior of each output can be customized. The
OnDelay is always active and will delay the input to output transition by the set
time. The ModeOutput for respective output decides whether the output shall be
steady with an drop-off delay as set by OffDelay or if it shall give a pulse with
duration set by PulseTime . Note that for pulsed operation and that the inputs are
connected in an OR-function, a new pulse will only be given on the output if all
related inputs are reset and then one is activated again. For steady operation the
OffDelay will start when all related inputs have reset. Detailed logical diagram is
shown in figure 167
1MRK 505 384-UEN A
Section 10
Logic
Breaker protection REQ650 2.2 IEC 345
Technical manual