USO
RESTRITO
294
Macro Attachment Assigning
Macro
attachment
location
Buttons
ICP-6520/6530
ICP-3000/3016
M/E bank,
PGM/PST
bank
[MCRO ATTCH
ENBL] button on the
cross-point control
block
[MCRO ATTCH
ENBL] button in the
1st row on the cross-
point control block
All other
locations
• User preference button on the menu panel
with the
“Macro Attachment Enbl”
assignment
• 2nd row button on the cross-point control
block with the
“Macro Attachment Enbl”
assignment using the utility/shotbox
function
Ch
a
p
te
r 15
M
a
c
ro
s
To delete all macro attachment settings in a
single operation
1
Open the Macro >Attachment menu (5421).
2
Press [All Clear].
3
Check the message, then press [Yes].
Switching the macro attachment
assignment mode (button number mode/
pair number mode)
When assigning a macro attachment to a cross-point
button, you can select the mode as either by button number
or by pair number (video and key).
Notes
If you change the mode using the following procedure, all
macro attachment data relating to cross-point buttons is
lost.
1
Open the Macro >Attachment menu (5421).
2
In the <Xpt Attachment Mode> group, select one of
the following.
Button Mode:
Button number mode. Assign an
attachment combination of bus and button
numbers.
Pair Mode:
Pair number mode. Assign an attachment
combination of bus and pair numbers.
3
Check the message, then press [Yes].
Displaying the Macro Attachment
List
In the Macro >Attachment menu (5421), you can display
the macro attachment list to check the macro attachment
settings.
The macro attachment list includes the following columns.
•
Block:
Shows the names of control panel blocks.
•
Button:
Shows the names of macro attachment assigned
buttons (of up to 30 characters).
•
Reg:
Shows the names of assigned registers.
•
Name:
Shows the names of macro registers.
•
Mode:
Shows the names of macro modes (Pre/Post/
Only/---
1)
).
Above the list is shown the names of the block and macro
attachment assigned button currently selected in the list.
1) When no macro mode is set
For details about the macro modes,
attachment to a button” (p. 291)
For details about the macro attachment listing,
the Macro Attachment List Display” (p. 429)
Moving within the list from one block to
another
You can move quickly from the current block to another
block to check the settings for that block by pressing the
following buttons in the <Block Select> group.
•
P/P:
Move to a block in the PGM/PST bank.
•
M/E-1:
Move to a block in the M/E-1 bank.
•
Others:
Move to a block in a location other than the
PGM/PST bank or M/E-1 bank
Notes
• In pair number mode, carry out operations as follows.
- When a single pair number is assigned to multiple
cross-point buttons, pressing any of them executes the
macros of all cross-point buttons to which the same
pair number is assigned. Further, if you delete any of
these assignments, this deletes all assignments to the
same pair number.
Executing a Macro by Macro
Attachment
You use the following buttons to execute a macro
attachment.
- If you reassign a pair number to a different cross-point
button, the attachment settings are also transferred to
the new cross-point button.
•
When macro attachment data is loaded to overwrite
existing data, this also changes the button number mode
or pair number mode setting.
