USO
RESTRITO
362
Interfacing with External Devices
Ch
a
p
te
r 19
S
wi
tc
h
e
r S
e
tu
p
Test firing the trigger
Press [Test Fire].
This outputs a trigger from the selected output port. This is
no output when the trigger type is “Status.”
Enabling or Disabling AUX Bus
Control
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [AUX Control].
The AUX Control menu (7337.5) appears.
2
Select the 9-pin port for the setting from the <Control>
group.
Remote S1:
Makes the settings for the Remote S1
port.
Remote S2:
Makes the settings for the Remote S2
port.
3
Select the AUX bus.
4
Select whether to enable or disable AUX bus control
from the <Control Mode> group.
Enable:
Enables control of the port selected in step
2
.
Disable:
Disables control of the port selected in step
2
.
Manual:
Sets whether control of the port selected in
step
2
is possible or not depend on the setting in
the Misc menu.
5
Repeat steps
2
to
4
as required to make the settings for
other ports.
Setting the AUX Bus Output and
Reentry Input
You can select the signal input to the DME (AUX bus
output) and the signal returned as the switcher primary
input (reentry input).
1
Open the Engineering Setup >Switcher >Device
Interface >DME SDI I/F menu (7337.7).
2
Select the DME channel to set.
3
In the <Select> group, select the AUX bus or reentry
to be assigned to the DME channel.
Aux Bus:
Sets the AUX bus.
Re-Entry:
Sets reentry.
4
Depending on the selection in step
3
, set the Aux bus
output or reentry output.
5
Press [Set].
Repeat steps
2
to
5
as required.
Selecting the Mode for Turning Off
Keys upon Receiving the Editor
Command
Selects the mode for turning off keys when an “All Stop”
command is received from the editor.
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [Editor I/F].
The Editor I/F menu (7337.8) appears.
2
Select one of the following modes.
All:
When an “All Stop” command is received, all
keys for the selected regions are turned off.
Specified:
When an “All Stop” command is received,
among all the keys for the selected regions, only
the keys specified by the editor are turned off.
Notes
When an “All Stop” command is received in the
process of a transition, the keys selected for the next
transition are also turned off.
Notes
When using the MVE-8000A, it is not possible to
select any of DME1 Ext In to DME8 Ext In.
