USO
RESTRITO
118
Basic DME Wipe Setting Operations
No.
Parameter
Adjustment
1
H
Crop the left and right of the
image
(“Left” value is displayed)
2
V
Crop the top and bottom of the
image
(“Top” value is displayed)
3
All
Crop the left, right, top, and
bottom of the image
(“Left” value is displayed)
No.
Parameter
Adjustment
1
Top
Crop the top of the image
2
Left
Crop the left of the image
3
Right
Crop the right of the image
4
Bottom
Crop the bottom of the image
Ch
a
p
te
r 6
DM
E
W
ip
e
s
Parameter group [1/2]
Parameter group [2/2]
Linear:
The cropping is removed linearly through the
whole course of the transition (enlarges).
Transitions
Cropping
t: Transition execution
time
y: Change in transition
and cropping amount
Display indications when multiple channels are
selected at the same time
The indications for the parameters show the settings
on channel 1. When you adjust the settings, this
changes the settings on channel 2 by the same amount.
To crop to 4:3 aspect ratio in 16:9 mode
In the <Crop Mode> group, press [4:3 Crop], turning it on.
To set the action when a DME wipe crop
transition is executed
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
If the selected pattern is in 2-channel mode, in the <Ch
Select> group, select the corresponding channel.
You can select more than one channel at the same
time.
3
In the <Crop Mode> group, press [Crop] or [4:3 Crop]
(to crop from 16:9 to 4:3 aspect ratio), turning it on.
4
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
5
In the <Crop Transition> group, select the execution
mode for the DME wipe crop transition.
Cut:
Cut mode. The cropping does not change during
the transition, but at the end point of the transition,
the cropping is removed (enlarges).
Last 5%:
The cropping is maintained for the first 95%
of the transition, and is progressively removed
during the last 5% of the transition (enlarges).
To set the timing of transition completion
When the execution mode for a DME wipe crop transition
is set to [Last 5%], you can select the timing of transition
completion from 70% ([Last 30%]), 95% ([Last 5%]), and
100% ([Off]).
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
3
In the <Release Transition> group, select the timing of
transition completion.
Last 30%:
The transition completes at the end of 70%
of the transition execution time. The transition has
a dead zone from 70% to 95% of the transition
time.
Last 5%:
The transition completes at the end of 95%
of the transition execution time. When the
transition completes, the cropping is removed
during the last 5% (enlarges).
Off:
The transition completes at the end of the
transition execution time. During the last 5% of
the transition, the transition and cropping removal
proceed together.
