-76-
6.1 Station number setting
Set the station number of each driver.
Station number setting method
Set the station number with the station number switches (STATION NO.) on the driver front. The station
number that may be set is any of 1 to 64 in decimal. In the initial status, the station number is set to
station 1.
X10 STATION No. X1
8
0
5
1
2
3
4
9
7
6
8
0
5
1
2
3
4
9
7
6
Servo amplifier
Set the tens. (initial value: 0)
Set the units. (initial value: 1)
POINT
Be sure to set the station numbers within the range of 1 to 64. Do not set any
other values, as they will not be valid.
How to number the stations
Set the servo station numbers before powering on the drivers. Note the following points when setting the
station numbers.
(a) Station numbers may be set within the range 1 to 64.
(b) One driver occupies 1 or 2 stations. (One station of programmable driver remote device station)
(c) Max. number of connected units: 42
Note that the following conditions must be satisfied.
{(1 a) (2 b) (3 c) (4 d)} 64
a: Number of 1-station occupying units
b: Number of 2-station occupying units
c: Number of 3-
station occupying units (not available for LECSC□-□)
d: Number of 4-
station occupying units (not available for LECSC□-□)
{(16 A) (54 B) (88 C)} 2304
A: Number of remote I/O stations 64
B: Number of remote device stations 42
C: Number of local stations 26
(d) When the number of units connected is 4, station numbers can be set as shown below.
CC-Link
master unit
Station No.1
Servo amplifier No.1
(When 2 stations are
occupied)
Remote device station
Station No.2
Number of connected units is 4.
Servo amplifier No.2
(When 2 stations are
occupied)
Remote device station
Station No.4
Servo amplifier No.3
(When 2 stations are
occupied)
Remote device station
Station No.6
Programmable controller
remote I/O station
(1 station occupied)
Driver
Driver
LECSC Driver No.1
LECSC Driver No.2
LECSC Driver No.3
