![background image](http://html1.mh-extra.com/html/smc-networks/lecsc-series/lecsc-series_operation-manual_1299642020.webp)
-18-
5. Parameter Configuration using Setup software (MR Configurator2
TM
)
This section describes the configuration procedure for main parameters using the setup software (MR
Configurator2
TM
: LEC-MRC2E). See chapter 6
of the “LECSC Operation Manual” for parameter details.
5.1Setup software (MR Configurator2
TM
)
*1 Setup software version 1.52E or above is required.
*2 The setup software (MR Configurator2
TM
:LEC-MRC2E) must be purchased as an additional item.
*3 The USB cable (LEC-MR-J3USB) must be purchased as an additional item.
5.1.1 Installation Method
Perform installation according to the “MR Configurator2
TM
instruction manual
” (Manual/ib0300160*.pdf) contained
on the setup software (MR Configurator2
TM
) CD-ROM. The
“MR Configurator2
TM
” software will be added to the PC.
5.2 Basic driver set-up for Initial Test Drive
Switch on the
main circuit power supply (AC100V/AC200V) and controller circuit power supply
(AC100V/AC200V) to the LECSC driver.
When the driver display flashes as shown below, it wires for EMG and ON (state of EMG release (operational)).
When wiring, I/O connector(LE-CSNA) or I/O cable(LEC-CSNA-1) is required.
(EMG (Forced stop) cannot be controlled with CC-Link.)
If the power supply is turned on for the first time, refer to "
LECSC Operation Manual”, chapter 5.