![background image](http://html1.mh-extra.com/html/smc-networks/lecsc-series/lecsc-series_operation-manual_1299642009.webp)
-7-
Introduction
It is recommended that the operator read the operation manual for LECSC prior to use.
For the handling and details of other equipment, please refer to the operation manual for used equipment.
Check that the main circuit power supply (AC100V/AC200V) and controller circuit power supply
(AC100V/AC200V) are wired correctly.
When using the emergency stop SW etc. provided by customer, wire it to the EMG (Forced stop) of the
input/output signal(CN6-1).
When wiring, I/O connector(LE-CSNA) or I/O cable(LEC-CSNA-1) is required.
(EMG (Forced stop) cannot be controlled with CC-Link.)
Please put the wiring for EMG (Forced stop) into the state of EMG release (operational).
(EMG (Forced stop) can be compulsorily set to automatic ON by the parameter.)
Please refer to chapter 4
of the “LECSC Operation Manual” and chapter 3 of the “LECSC Operation Manual
(Simplified Edition)
” for details.
When setup software (MR Configurator2
TM
) is used, the LECSC
□-□ model selection is required.
Select 'MR-J3-T
' through “Model" - "New" and "Project".