![background image](http://html1.mh-extra.com/html/smc-networks/lecsc-series/lecsc-series_operation-manual_1299642025.webp)
-23-
5.3.1 Change of parameter block
To enable settings for all parameters.
①
Select “Basic settings (list)” tab and change “PA19” value to “000C”.
②
Click the “PA19” row then click “Selected Items Write”.
③
Cycle the power off, then on for parameters for this driver to be enabled.
④
Please click “Read".
When changing of each parameter, note the following points.
Note1) Some of the various parameters, there is "
Enable once on again turning the power OFF after
setting
". (If you do not the power to OFF, it does not reflect the data in the driver.)
Note2)
“Selected Items Write”: It writes the parameter values of the corresponding frame to the driver.
“Single Axis Write”: It writes all of the parameters to the driver.
Note3)
Do not change “For manufacturer setting” parameters.
If you change by these by mistake, it may cause
the amplifier to not work properly.
5.3.2 Change of parameter block
If you read the parameters of the driver to the software, please do the
“read” operation.
①
From the View menu bar "parameter (A)" - please click on the "parameter setting (P)". "Parameter
Settings" screen will display.
②
Please click on
the “Read".
②
②
①
④