-101-
6.8 Write instruction code No. (8010h to 91FFh)
Set the data, which was requested to be written with the write instruction code No. (8010h to 91FFh).
Set the instruction code No. corresponding to the item to Instruction code (RWwn+2) and the written data to Writing
data (RWwn+3). The codes and answer data are all 4-digit hexadecimal numbers.
When the instruction code which has not been described in this section is set, the error code (
1 ) is stored in
respond code (RWrn+2).
Write
instruction
Code No.
Item
Writing data (RWwn 3) contents
(Programmable PC or PLC...etc
LECSC Driver)
8010h
Alarm reset command
Deactivates the alarm that occurred.
1EA5
8101h
Feedback pulse value display data is clear
Resets the display data of the status indication
"feedback pulse value" to 0.
1EA5
8200h
Parameter group write command
Writes the group of parameters that are written
to with codes No.8201h to 82FFh and 8301h
to 83FFh.
Writes the group of parameters that are read
with codes No.0201h to 02FFh and 0301h to
03FFh.
Parameter group
0: Basic setting parameters (No.PA )
1: Gain/filter parameters (No.PB )
2: Extension setting parameters (No.PC )
3: I/O setting parameters (No.PD )
0 0 0
8201h (1)
to
82FFh (255)
Data RAM instruction of parameter
Writes the set value of each No. of the
parameter group written by code No.8200h to
RAM. These values are cleared when power
is switched off.
The decimal value converted from the 2 lower
digits of the code No. corresponds to the
parameter No.
An error code is returned if an instruction code
outside the range set in parameter No. PA19
or a value outside the setting range of the
corresponding parameter is written.
Convert the decimal values into hexadecimal before setting.
8201h (1)
to
82FFh (255)
Data RAM instruction of parameter
Writes the set value of each No. of the
parameter group written by code No.8200h to
RAM. These values are cleared when power is
switched off.
The decimal value converted from the 2 lower
digits of the code No. corresponds to the
parameter No.
An error code is returned if an instruction code
outside the range set in parameter No. PA19
or a value outside the setting range of the
corresponding parameter is written.
Convert the decimal values into hexadecimal before setting.
8301h (1)
to
83FFh (255)
Data EEP-ROM instruction of parameter
Writes the set value of each No. of the
parameter group written with code No.8200h
to EEP-ROM. Written to EEP-ROM, these
values are held if power is switched off.
The decimal value converted from the 2 lower
digits of the code No. corresponds to the
parameter No.
An error code is returned if an instruction code
outside the range set in parameter No. PA19
or a value outside the setting range of the
corresponding parameter is written.
Convert the decimal values into hexadecimal before setting.
