MX-3114N ADJUSTMENTS AND SETTINGS 5 – 38
b. Adjustment procedure
(Auto color balance adjustment by the serviceman)
YES
NO
NO
YES
YES
NO
Copy color balance and density adjustment (Automatic adjustment)
(SIM46-24) procedure flowchart
Start
Execute ADJ10C(1) Copy color balance and density adjustment
(automatic density).
Enter the SIM46-24 mode, and select A4 (11" x 8.5") paper.
(Automatic selection)
Press [EXECUTE] key. (The adjustment pattern is printed.)
Set the adjustment pattern on the document table. Select the
FACTORY target or the SERVICE target, and press [EXECUTE] key.
(The adjustment pattern is scanned, and the adjustment is
automatically performed to print the check pattern.) (*1)
Check the printed check pattern for any streaks or unclear copy. (*4)
Press [OK] key, and the initial setting of the halftone image correction
is automatically performed. (*3)
Cancel SIM46-24
Check the color balance and density adjustment result.
Use the test chart (UKOG-0326FCZZ/UKOG-0326FC11) to make a
copy in the Text/Printed Photo mode, and check the copy color bal-
ance and density.
Use SIM46-21 to print the color balance check pattern, and check the
patch color balance and density in the process gray. (If the color bal-
ance is slightly shifted to Magenta, it is properly adjusted.)
Are the color balance and den-
sity at the satisfactory level?
Check that the initial setting of the halftone image correction was properly
performed. (*3)
Execute the initial setting of the halftone image correction.
(SIM44-21)
Execute the halftone image correction. (SIM44-26)
Use the test chart (UKOG-0326FCZZ/UKOG-0326FC11)
to make a copy in the Text/Printed Photo mode, and check
the color balance and density.
Are the color balance and den-
sity at the satisfactory level?
End
Automatic color balance target change
Change the color balance and
density target. (SIM63-11)
Though the
FACTORY color
balance and density
target (available in 3 kinds)
is changed, satisfactory color
balance and density are not
obtained (SIM63-11),
or the SERVICE
target is selected.
*1:
When the copy color balance and density are
customized and registered as the SERVICE
target, select the SERVICE target.
*2:
If satisfactory color balance and density are
not obtained with ADJ10C(2) (Manual copy
color balance and density adjustment)
(SIM46-21/44-21), check the print engine for
any problems.
*3:
If the initial setting of the halftone image
correction is not properly made, satisfactory
color balance and density cannot be
obtained. In this case, check the print engine
for any problems.
*4:
If there is any streak or unclear copy on the
printed check pattern, check the print engine
for any problems.
Execute ADJ10C(2) (Manual copy color
balance and density adjustment).
(SIM46-21/44-21).(*2)
