MX-3114N DISASSEMBLY AND ASSEMBLY 10 – 29
• Check that there is proper amount of developer.
(The stirring screw can be partly seen.)
• There is no developer in the shutter position.
• There is too much developer.
(The stirring screw cannot be seen.)
Be sure to keep the developing unit level while supplying the
developer.
7)
Insert the developing unit so as not to give a strong shock to
the main unit.
Slide the developing unit horizontally into the machine, in the
direction of the arrow, until developing unit locks into. place.
Do not push the unit diagonally, as contact with the drum may
occur causing damage.
When removing or installing the developing unit, put your hand
from below the unit and slide it in parallel along the guide.
At that time, be careful not to touch the roller surface.
When performing the above operation, there is no need to
uninstall or install the OPC drum unit. If it must be uninstalled
or installed for any reason, follow the procedures below. When
uninstalling or installing the OPC drum unit, put your hand from
below the unit and slide it in parallel along the guide on the
right side.
At that time, be careful not to touch the OPC drum surface.
8)
Set the ADJ 1C toner density control reference value.
b. DV seal
1)
Remove the DV seal.
Remove the cover with a screwdriver (-) from the rear side. At
that time, be careful not to break the boss on the front side.
When attaching the DV seal to the cover, use care and do not
wrinkle the seal.
