Sharp AR-M550N, Service Manual, Page: 249 / 460

: Feb. 9 2004
1
AR-M550/M620/M700 SETTING AND ADJUSTMENTS 7 - 34
1) Set the test chart (UKOG-0162FCZZ) on the original table so that it
aligns with the front frame. Then put four or five pieces of A3 (11" x
17") paper .
2) Go through the modes specified in Simulation 46-12.
3) Select the adjustment item (FAX EXP. LEVEL) using the numeric
keypad.
4) Press the Start key.
5) Press the Start key (A copy is created.)
Check the print density.
If the print density is not at an acceptable level, do the following
steps.
6) Enter the print adjustment value using the numeric keypad.
7) Press the P or Start key
This applies the adjustment value.
Pressing the Start key starts print operation as well as applying the
adjustment value.
8) Check the print density.
Repeat steps 6 to 8 until an acceptable print density is obtained.
Note: Adjusting the Fax print density through this simulation changes
the print density settings for all Fax modes to the density level
applied by carrying out this simulation.
The Fax mode print density settings for individual Fax modes
adjusted through Simulations 46-13, -14, -15, -16 and -45 are
changed to the print density level applied by this simulation.
This adjustment is intended to the print mode for each Fax mode indi-
vidually. In manual mode, the print density setting for each print density
adjustment level (1 to 5) can be adjusted to a custom density level.
1) Set the test chart (UKOG-0162FCZZ) on the original table so that it
aligns with the front frame. Then put four or five pieces of A3 (11" x
17") paper .
ADJ 10A Adjust the fax mode print density for all
modes at once
Select 0, and
press [START] key. Press [START] key, or
press [CUSTOM SETTINGS] key.
Item
Set
range
Default
0 TRAY SELECT Paper feed tray selection
1 COPY START Copy START (Default)
2 FAX EXP. LEVEL FAX mode print density 0 - 99 50
00
SIMULATION 46-12
EXP.LEVEL SETUP FAX(AUTO SET). SELECT 0-2, AND PRESS
START.
0.TRAY SELECT 1 1.COPY START
2.FAX EXP.LEVEL 50
Press [CUSTOM SETTINGS] key.
SIMULATION 46-12
EXP.LEVEL SETUP FAX(AUTO SET), INPUT VALUE 0-99, AND
PRESS START.
2.FAX EXP.LEVEL
50
1
Press [START] key.
Press [CUSTOM SETTINGS] key,
or terminate copying.
SIMULATION 46-12
EXP.LEVEL SETUP FAX(AUTO SET). NOW PRINTING.
Select 1, and
press [START] key.
Select other than 0 - 1, and
press [START] key.
SIMULATION 46-12
EXP.LEVEL SETUP FAX(AUTO SET).SELECT 1-6, AND PRESS
START.
(FEED TRAY)
1.TRAY1 2.TRAY2 3.TRAY3 4.TRAY4
5.BPT 6.LCC
ADJ 10B Adjust the fax mode print density in
standard mode
ADJ 10C Adjust the fax mode print density in
small-character mode
ADJ 10D Adjust the fax mode print density in fine
mode
ADJ 10E Adjust the fax mode print density in
super fine mode
ADJ 10F Adjust the fax mode print density in
600dpi mode
00