SeeMeCNC Rostock MAX v2, Assembly Manual

Page: 258 / 314

Rostock MAX v2 Assembly Guide
The effector platform provides three mounting locations for the layer fan. Yes, you can install
three of them if you really want. :)
With the machine powered off, slide each
Cheapskate down to the base of the tower so that your hot
end is at the top of a pyramid formed by the three arms.
Lay a washcloth or towel on your heated bed to protect it
while you're working on the hot end.
Choose a mounting point and test fit the shroud. It
should be a snug fit, but if it' won't fit at all, you may need
to lightly sand it with a fingernail file.
Leave the fan sitting at the position you chose and
solder the fan leads to the last remaining 26ga wire pair
coming out of the mesh loom. Cover the solder joints
with Kapton tape and use a #4 machine screw to fix the fan shroud into place.
Before you return the hot end to its operating position, turn on the printer and connect
MatterControl to it. You're going to test the fan to make sure it works and the fan blades don't rub on
the shroud.
Click on the Controls pane and then set the fan speed to 100% by clicking on the box next to
the “Fan Speed:” label and then enter “100” followed by pressing ENTER or clicking the “ Set ” button.
258
Fig. 21-5: Layer fan mounting points.
Fig. 21-6: Layer fan & mount installed.