Rostock MAX v2 Assembly Guide
To install the EZStruder on to the support bracket, orient the EZStruder and support bracket as
shown in Fig. 10-13.
Carefully slide the stepper motor through the square opening in the bracket and guide the two
screws into their mating holes on the bracket as shown below. The stepper is a tight fit, but it does fit
properly once the input angle is taken out of it.
142
Fig. 10-13: Bracket & EZStruder orientation.
Fig. 10-14: Fitting the EZStruder to the
bracket.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...
