Riso RZ5 Series, Technical Manual, Page: 97 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 8: PRINT DRUM SECTION
[ 8 - 9 ]
< Precautions in Reassembly >
(1) Mount and screw the top hanger on the print drum and wrap the screen around the drum. Then tentatively
attach the screws on the tail hanger, very lightly.
2) Hook the screen jigs through the holes on the left and right of the tail hanger, pull the screen jig and hook
the loop end of the jigs on the short pillars on the left and right drum flanges, located close to where the top
hanger is. This is to tension the screen assembly tightly and evenly around the print drum.
(3) With the screen assembly tightly wrapped around the drum by the screen jig, tighten the screws on the tail
hanger.
(4) Remove the screen jigs from the print drums once the screws on the tail hanger are tightened.
Tail hanger
< Screen JIG >
Screen assembly
Screen JIG
Top hanger
Screen JIG
Tail hanger
< FRONT >
Screen assembly
Top hanger
< REAR >
0815
0816
0817
Pillar to which the loop of the
jig is to hook.