Riso RZ5 Series, Technical Manual, Page: 239 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 14: PANEL MESSAGE
[ 14 - 21 ] RZ5 (Revision 1.0)
Option errors
Error Type B01 [Keycard counter: No card]
Description
B01-xxx
Insert Card in Key/Card Counter
To reset
display
Insert card.
Error Point Error Conditions
730 Keycard counter: No card
Error Type B22 [Job separator: Power off]
Description
B22-xxx
!! Job Separator is OFF !!
Turn On Power Switch of it
To reset
display
Press Reset Key and check and switch ON the power of Job Separator.
Error Point Error Conditions
721
With the “Tape separation” function set ON, no power is supplied to the job separator when
start key is pressed.
727
After cluster-A signal turned ON, BUSY-signal stayed "L" more than 7 seconds (power to job
separator was turned OFF while the tape is being ejected.
Error Type B23 [Job separator: No tape]
Description
B23-xxx
No Paper Tape in Job Separator
Replace Tape Roll
To reset
display
Press Reset Key and set paper tape in Job Separator.
Error Point Error Conditions
722
With the “Tape separation” function set ON, no tape detected in the job separator when the
start key is pressed.
723 No tape remains in job separator upon completion of the tape-ejection operation.
Error Type B24 [Job separator: Tape jam]
Description
B24-xxx
Paper Tape Jam in Job Separator
Remove Paper Tape
To reset
display
Press Reset Key and remove the jammed tape.
Error Point Error Conditions
724
Tape jam detected when the start key is pressed with the “Tape separation” function set to
ON.
725
The tape-jam detection signal is "H" for more than 1.2 seconds after cluster-A signal turns ON
(tape misfeed).
726
Job separator tape-jam detection signal is “L” when the BUSY signal changes from “L” to “H”
(or after 7 sec. at “L”) after the cluster-A signal goes ON (tape misfeed).