Riso RZ5 Series, Technical Manual, Page: 227 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 14: PANEL MESSAGE
[ 14 - 9 ] RZ5 (Revision 1.0)
Error Type T15 [AF error]
Description
T15-xxx
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
To reset
display
Turn OFF and ON the power.
Error Point Error Conditions
004 Communication error with AF-CPU.
110
ABC (auto-base-control) timeout. The original does not move from the ABC scanning position
on the AF unit.
111 Operation command was made to the AF unit without 24 volts supplied to the AF unit.
130
Timeout error in receiving reply from the AF unit after command signal was sent from the Riso
printer to the AF unit.
131 Riso printer received an undefined command from the AF unit.
132 Riso printer detected communication sequence error from the AF unit.
133 Communication error with AF unit (ACK, NAK, or receiving channel error).
134 Riso printer could not send command to the AF unit within the set time.
160 AF unit detection signal went OFF while the AF unit is in operation.
161 AF unit not connected.
Error Type T14 [Flatbed error]
Description
T14-xxx
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
To reset
display
Press Reset Key.
Error Point Error Conditions
114 Incorrect main-unit data.
115 The scanner operation is not completed within the set time.
116 Timeout error for black shading compensation.
117 Timeout error for white shading compensation.
118 Software error
123 Offset adjustment not completed within set time.
124 Gain adjustment not completed within set time.
125 Offset adjustment not completed.
126 Gain adjustment not completed.
135 Malfunction detected during offset adjustment.
136 Malfunction detected during gain adjustment.
137 Malfunction detected during black shading compensation.
138 Malfunction detected during white shading compensation.
170
Even though the read pulse motor stopped according to the sensor detection, the stopping
position does not correspond with the programmed position. (GA control error).