Riso RZ5 Series, Technical Manual, Page: 224 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 14: PANEL MESSAGE
[ 14 - 6 ] RZ5 (Revision 1.0)
Error Type T03 [Clamp motor lock]
Description
T03-xxx
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
To reset
display
Press Reset Key
Error Point Error Conditions
500
Clamp sensor A is OFF after the completion of the clamp unit initialization or home positioning
movement.
501
Clamp sensor B does not change within 1 second from the time the clamp motor operates in
the forward direction.
502
Clamp sensor B does not change within 1 second from the time the clamp motor operates in
the reverse direction.
503
Clamp sensor A does not go ON within 3 seconds when the clamp unit makes initialization
movement.
504
At the start of Clamp plate open/close action, the detection sequence of clamp-sensors A &
B are abnormal.
505
At the start of print drum Position-A compensation movement, the detection sequence of
clamp-sensors A & B are abnormal.
506
At the start of Clamp unit Home-positioning movement, the detection sequence of clamp-
sensors A & B are abnormal.
507 Clamp sensor A is ON after the clamp release action is completed.
508 Clamp sensor A is ON after the A-position compensating movement is completed.
545
Clamp unit is not in the home position while the print drum is in movement (cause due to the
clamp motor).
Error Type T04 [Ink overflow]
Description
T04-xxx
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
To reset
display
Press Reset Key after correcting the ink overflow condition. (No ink on the ink overflow
sensor.)
Error Point Error Conditions
513
The overflow sensor is ON for a set number of times in succession during the 10-millisecond-
interval overflow-sensor check.
manuals4you.com