Riso RZ5 Series, Technical Manual, Page: 177 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 12: AF SCANNING SECTION
[ 12 - 15 ]
Removing the original ejection roller
(8) Remove the E-ring, timing pulley and metal bushing from the front side of the original ejection roller. Then,
remove the E-ring, washers, thrust spring and metal bushing from the rear side of the roller.
* Be careful that the washer and the thrust spring may fly out of the roller shaft when the E-ring is removed.
- Refer to the precaution in reassembly at the bottom of this page -
< Precautions in Reassembly >
[ for the Registration Roller, Read Roller and Original Ejection Roller ]
- Install the washers on both ends of the thrust spring on the rear side of each roller and then hook the E-ring.
- Make sure that the flanges on the timing pulley faces the correct direction on each roller.
Timing pulley
Washer
Thrust spring
Washer
1318
< Front > < Rear >
Registration Roller
Metal bushing
E-ring
E-ring
Metal bushing