Riso RZ5 Series, Technical Manual, Page: 273 / 410

RISO Inc. Technical Services & Support US.RISO.COM
CHAPTER 1: MAINTENANCE
[ 1 - 5 ]
Type Tip size Shaft length, etc.
Phillips screw driver
No. 2
No. 2
No. 2
No. 1 (250 mm)
(100 mm–150 mm)
(stubby type)
(75 mm–100 mm)
High frequency
driver
2.5 mm
5.0 mm 4.0 mm 3.0 mm
2.5 mm 2.0 mm 1.5 mm
(For 3.0mm, 2 pieces required )
Spanners
Hex w renches
Standard
screw driver
Nut driver
(box driver)
5 mm 5.5 mm 7 mm
8 mm 10 mm 13 mm
Monkey
6 mm
3 mm
1.8 mm
(100 mm–150 mm)
(100 mm–150 mm)
(precision type)
8 mm
7 mm (100 mm–150 mm)
(100 mm–150 mm)
Type Rem arks
Steel scale 150 mm
Feeler gauge
Radial cutting pliers
Pliers
Nipper
Small flashlight
Multimeter
Soldering iron 20 W–30 W
File Flat, round
1. Work Precautions
When conducting maintenance work, be careful to avoid injury caused by springs or the sharp
edges of sheet metal.
Inspection
If you discover any defects or problems during an inspection, fix the problems or if necessary take steps
such as replacing a part.
Removal
Check the problem area. At the same time, examine the cause of the problem and determine whether
the part needs to be removed or disassembled. Next proceed according to the procedures presented in
the Technical Manual. In cases where, for example, it is necessary to disassemble areas with large
numbers of parts, parts which are similar to each other, or parts which are the same on the left and right,
sort the parts so that you do not mix them up during reassembly.
(1) Carefully sort the removed parts.
(2) Distinguish between parts which are being replaced and those which will be reused.
(3) When replacing screws, etc., be sure to use the specified sizes.
Assembly and Installation
Unless specified otherwise, perform the removal procedures in
reverse during assembly and installation. In cases where
protrusions or holes are provided to assist in positioning parts,
use them for accurate positioning and securing.
(Protrusions and holes for positioning parts Half pierced
section)
Tools
Using tools other than those specified can lead to injury or
damage screws and parts. Have all the tools necessary for the
work available.
[Standard Tool list]
Half-pierced section
0102
0103
0101