![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621086.webp)
*NOTE: A Helper will be needed to complete this Step.
*NOTE: Rail Uprights (3137) should not have been installed in the opening that the Monkey
Bar is being installed in. If Rail Uprights were installed, remove and reinstall after
Monkey Bar has been installed.
1. In the opening the Monkey Bar is being installed in, measure over from inside face of Upright
1 11/16"
and
22 3/16"
, and drill two
9/16" diameter holes
through top of Accessory Arm using a
9/16" drill
bit
(as shown in Inset A).
*NOTE: The 9/16” diameter holes must be drilled in the center of the Accessory Arm. Holes
must measure 20 1/2" apart when properly drilled.
2. On the ground, position Monkey Bar inside of Monkey Bar Support, lining up the bottom holes in the
Support with the upper hole in the Monkey Bar (as shown).
*NOTE: Monkey Bar must be oriented, with the counter bored holes towards the end of the
Monkey Bar, pointing up (as shown).
3. Attach Monkey Bar Support to Monkey Bar using 3/4” Hardware
(H5)
and 1/2” Hardware
(H4) (H12)
(H18) (H71)
. Do not fully tighten Hardware at this time.
4. Lift up on Monkey Bar and position Monkey Bar Brackets
(7024) (7025)
against Monkey Bar and
Support so that all faces of Monkey Bar, Support and Brackets are flush. Attach Monkey Bar
Brackets to Monkey Bar and Monkey Bar Support using 3/8” Hardware
(H3) (H116)
.
*NOTE: There should be no gaps in all adjoining faces of Monkey Bar Brackets, Monkey Bar
& Monkey Bar Support when properly installed.
5. Lift Monkey Bar assembly up into opening, to underside of Accessory Arm
(6134)
, and align holes
in Monkey Bar with previously drilled holes in Accessory Arm.
6. Attach Monkey Bar to Accessory Arm
(6134)
using 3/4” Hardware
(H5)
and 1/2” Hardware
(H4) (H12)
(H18) (H29) (H76)
.
7. Check that Monkey Bar is level and fully tighten Hardware from #3. Attach 1/2” Hardware
(H29)
to
the end of 1/2” Hardware
(H71)
from #3.
8. Measure up from bottom of Monkey Bar Support
23”
and attach Ladder Handles
(N6)
to Support
using #14 Hardware
(H167)
.
Continued on next page:
85
Step 40
60" Deck Height Monkey
Bar Installation