![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621121.webp)
A
H3
H11
H125
H226
H34
N371
4051
N381
INSET B
MATCH DRILL
THROUGH
THESE HOLES
19 3/4"
12"
14" DEEP
HOLE
TOP VIEW OF SET
N371
INSET A
COIL CLIMBER
B
H3
H116
6134
N381
N371
INSET C
*WARNING: LOCATE ALL UNDERGROUND UTILITIES BEFORE DIGGING.
1. Measure out from set
19 3/4"
, and in from Upright
12"
, and dig a hole approximately
14" deep
for
Coil Climber assembly to sit in (as shown in Top View of Set).
2. Locate one Coil Climber Extension
(N371)
and thread Extension onto Coil Climber (as shown in
Inset A).
*NOTE: Only one Coil Climber Extension will be used.
3. Insert assembled Coil Climber onto Fire Pole Top
(N381)
and secure to Fire Pole Top using #8
Hardware
(H226)
(as shown in Inset B).
4. Lift assembled Coil Climber up against 6 Hole Facia
(4051)
, center in opening, and match drill
through Fire Pole Top
(N381)
and Facia using a
7/16" drill bit
(as shown in Inset B).
5. Attach Coil Climber assembly to 6 Hole Facia
(4051)
using 3/8" Hardware
(H3) (H11) (H34) (H125)
.
*NOTE: A small hammer or mallet may be needed to pound in 3/8" Hardware (H34).
6. If installing Coil Climber on 60" Deck Height, position Coil Climber against Accessory Arm
(6134)
and attach using 3/8" Hardware
(H3) (H116)
(as shown in Inset C).
7. Ensure Coil Climber is plumb and fill hole around Coil Climber with concrete.
!
120
Step 72
Coil Climber
Installation