![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621044.webp)
70"
95 5/8"
58"
A
4050
4050
4051
6173
6173
H3
H116
H3 H11
H131
H3
H116
H3
H116
H3
H116
HOLES
OFFSET
UP
HOLES
OFFSET
DOWN
HOLES
OFFSET
DOWN
T-NUTS
POUNDED
INTO BACKS
OF UPRIGHTS
FLUSH
FLUSH
6132
6131
HOLES
OFFSET
INSET A
B
INSET B
H34
6173
1. Using a hammer, pound 3/8" T-Nuts
(H34)
into the bottom holes in the Corner Uprights
(6173)
(as
shown in Inset B). Stand up both wall assemblies and attach 4 Hole Facia
(4050)
using 3/8 Hardware
(H3) (H11) (H34) (H131)
. Holes in 4 Hole Facia
(4050)
must be offset as shown in Inset A.
*NOTE: Ends and bottoms of 4 Hole Facias (4050) must be flush with Uprights (6173) when
properly installed.
2. Ensure wall assemblies are plumb and finish attaching 4 Hole Facia
(4050)
, through top holes, using
3/8" Hardware
(H3) (H116)
.
3. Measure up
70"
and attach 4 Hole Facias
(4050)
to Corner Uprights
(6173)
using 3/8" Hardware
(H3)
(H116)
. Holes in 4 Hole Facias
(4050)
must be oriented as shown with offset holes up.
*NOTE: If installing Spiral Slide on base, do not install 6 Hole Facia (4051). Refer to Step 76
for Facia installation instructions.
4. Position 6 Hole Facias
(4051)
up
95 5/8"
from bottoms of Uprights and flush with the bottoms of the
Top Joists
(6131) (6132)
. Facias must be oriented as shown with offset holes down.
5. Attach 6 Hole Facias
(4051)
to Corner Uprights
(6173)
using 3/8" Hardware
(H3) (H116)
. Wall
assemblies must measure
58"
apart when properly installed.
43
Step 4
Wall Support Assembly