H155
H155
3154
3154
3154
3404
3404
4027
4027
ROUTERED
HOLES UP
COUNTER BORED
HOLES FACING IN
23 3/4"
0"
24 1/4"
48 1/2"
72 3/4"
97"
INSET A
ENDS
FLUSH
H155
3154
4027
4029
4027
*NOTE: For ease of assembly, construct Ramp on a flat level surface.
1. Lay Ramp Boards with Holes
(4027)
on ground with the routered holes facing up.
2. Position Ramp Rails
(3404)
against Ramp Boards with Holes
(4027)
, with counter bored holes facing
in, and attach using #8 Hardware
(H155)
.
*NOTE: Ends of Ramp Boards with Holes (4027) and Ramp Rails (3404) must be flush when
properly assembled.
3. Position Ramp Cleats
(3154)
on top of Ramp Boards with Holes
(4027)
and pushed up against Ramp
Rails
(3404)
using measurements shown in Inset A. Attach Ramp Rails
(3404)
to Ramp Cleats
(3154)
using #8 Hardware
(H155)
.
4. Flip Ramp over and attach Ramp Boards
(4029)
and Ramp Boards with Holes
(4027)
to Ramp Cleats
(3154)
using #8 Hardware
(H155)
.
*NOTE: Be sure that Ramp Boards (4029) are oriented so that the pre-drilled holes line up with
the pre-drilled holes in Ramp Boards with Holes (4027).
*NOTE: Ends of Ramp Boards (4027) (4029) must be flush when properly installed.
115
Step 66
Ramp Assembly