![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621110.webp)
B
INSET A
9 13/16"
11 3/16"
17 15/16"
H3
H116
4051
H155
3187
3186
H155
H116
H3
3188
3188
H155
3156
3157
6140
6174
6173
6174
6173
FACES
FLUSH
3 1/2"
28 3/8"
CUT OFF 3 1/2"
ROUTER &
STAIN CUT
END
6140
D
4051
6140
H34
H122
H11
H3
*NOTE: If installing Cabin Package, Short Center Post (6140) should have been modified
(as shown in Inset A).
1. Attach 3/8" Hardware
(H3) (H11) (H34) (H122)
in top hole of 6 Hole Facia
(4051)
(as shown in
Inset B).
*NOTE: A small hammer or mallet may be needed to pound in 3/8" Hardware (H34).
2. Position Arched Cabin Facias
(3188)
against Corner Uprights
(6173) (6174)
, pushed up tight to Roof
Runners, and attach using 3/8" Hardware
(H3) (H116)
.
*NOTE: Arched Cabin Facias should measure approximately 9 13/16" up from Accessory Arm
and Top Joist when properly installed.
3. Push Angled Cabin Facia
(3186)
up tight to Roof Supports
(3156) (3157)
, making sure that the faces
of Facias & Supports are flush (as shown). Attach Facia to Supports using #8 Hardware
(H155)
.
*NOTE: Bottom of Angled Cabin Facia should measure approximately 17 15/16" up from
6 Hole Facia when properly installed (as shown). Cabin Package will not be installed
in middle of set, between decks.
4. Push Arched Cabin Facia
(3187)
up tight to Roof Supports
(3156) (3157)
, making sure that the faces
of Facias & Supports are flush (as shown). Attach Facia to Supports using #8 Hardware
(H155)
.
*NOTE: Bottom of Arched Cabin Facia should measure approximately 11 3/16" up from
6 Hole Facia when properly installed (as shown).
INSET B
109
Step 60
Cabin Facia
Installation