![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621063.webp)
BOTTOM OF
ROCK WALL
BRACKETS ON
OUTSIDE OF LEGS
ROCKS MUST
BE FACING
DOWN
4049
3201
3201
H155
H155
4047
4048
3202
1/2"
3 5/16"
3 5/16"
42"
19 3/8"
TOP OF
ROCK WALL
FLUSH
FLUSH
4049
4047
4048
3202
*NOTE: Rock Wall should be assembled on a flat surface.
1. Position Rock Wall Legs
(3201)
on a flat surface
42"
apart from outside face to outside face, with
angle cuts facing up and previously installed Brackets facing out. Make sure ends of Rock Wall Legs
are flush.
2. Position top Rock Wall Board
(4047)
on top of legs
3 5/16"
down from ends of Rock Wall Legs
(3201)
.
Ends of Rock Wall Board must be flush with outside faces of Rock Legs. Attach Rock Wall Board
(4047)
to Rock Wall Legs
(3201)
using #8 Hardware
(H155)
.
*NOTE: Previously installed Rocks must be facing down when properly installed.
3. Layout remaining Rock Wall Boards
(4047) (4048) (4049)
referring to pattern shown in Inset A.
4. Ensure Rock Wall Boards are pushed up tight to each other and attach bottom Rock Wall Board
with Rope Hole
(4049)
using #8 Hardware
(H155)
.
5. Ensure all Rock Wall Boards are flush with Rock Wall Legs and Rock Wall is square. Attach remaining
Rock Wall Boards
(4047) (4048)
using #8 Hardware
(H155)
.
6. Flip Rock Wall assembly over. Center and hold Rock Wall Runner
(3202)
up tight to underside of
Rock Wall,
1/2"
down from top Rock Wall Board
(4047)
. Attach Rock Wall Runner
(3202)
through
front of Rock Wall using #8 Hardware
(H155)
.
*NOTE: Rock Wall Runner should measure 19 3/8" from outsides of Rock Wall Legs when
properly installed (as shown in Inset A).
INSET A
62
Step 21
Rock Wall
Assembly