*NOTE: Spiral Slide can only be mounted to base unit off the 70" Deck Height and only on the
Tarp Version.
1. Position 2 Hole Facia
(3405)
directly on top of 4 hole Facia
(4050)
, flush with Corner Uprights
(6173)
,
and attach using 3/8" Hardware
(H3) ( H116)
(as shown in Inset A).
2. Position 4 Hole Facia
(4030)
directly on top of 2 Hole Facia
(3405)
and attach to Corner Upright
(6173)
and Center Post
(6133)
using 3/8" Hardware
(H3) (H116)
(as shown in Inset A).
3. Measure up
30 7/8"
and
43 5/8"
and attach 4 Hole Facias
(4030)
to Corner Uprights
(6173)
and
Center Post
(6133)
using 3/8" Hardware
(H3) (H116)
(as shown in Inset A).
*NOTE: After Facias are installed, install Rail Uprights (3137) using processes shown in Step 18.
4. Center and attach one Filler Board
(3406)
, between previously installed 4 Hole Facias
(4030)
, using
#8 Hardware
(H154)
(as shown in Inset B).
5. Measure the two spaces made in between 4 Hole Facias
(4030)
attached to Center Post
(6133)
. Cut
the other Filler Board
(3406)
into two pieces to fill measured spaces. When cut, Filler Boards
(3406)
should measure approximately
7 3/8"
and
17 1/8"
(as shown in Inset B). Stain cut ends of Filler
Boards.
6. Attach newly made Filler Boards
(3406)
to Center Post
(6133)
using #8 Hardware
(H154)
(as shown
in Inset B).
*NOTE: Pre-drill 1/8" diameter holes in cut Filler Boards (3406) for #8 Hardware to avoid
splitting out Boards.
7. Lift assembled Spiral Slide up to opening and attach to Uprights
(6173) (6133)
using 1/4" Hardware
(H1)
and 5/16" Hardware
(H108)
(as shown Inset C).
*NOTE: Be sure to pre-drill holes for 5/16" lag bolts, through Filler Boards (3406), using a 1/8"
drill bit to avoid splitting out Filler Boards.
8. Finish attaching Spiral Slide to 4 Hole Facias
(4030)
using #14 Hardware
(H164)
(as shown in
Inset C).
Continued on next page:
126
Step 76
Facia & Spiral Slide
Installation
(for mounting on base unit)