B
H3
H155
H116
H3
H116
3404
3155
3404
4027
4029
4027
FILLER BOARD
PUSHED UP
TIGHT TO FACIA
4050
INSET B
H155
C
H3
H119
6134
INSET A
6005
D
6134
6005
N64
4050
DOUBLE
KNOT
DOUBLE KNOT
ON BACK SIDE
SINGLE
KNOT
1. On back side of Accessory Arm
(6134)
center and attach Ramp Rope Block
(6005)
using 3/8"
Hardware
(H3) (H119)
(as shown in Inset A).
2. Position assembled Ramp in opening and attach to Uprights using 3/8" Hardware
(H3) (H116)
.
*NOTE: Top of Ramp Boards (4027) (4029) must be flush with Deck (as shown).
3. On underside of Ramp, push Filler Board
(3155)
up tight to Facia
(4050)
and attach through Ramp
Boards
(4027) (4029)
using #8 Hardware
(H155)
(as shown in Inset A).
3. Finish attaching Filler Board
(3155)
to Ramp, on back side of Filler Board, using a qty. of two #8
Hardware
(H155)
.
4. Thread Rope
(N64)
through hole in Ramp Rope Block and tie a double knot on top of Block. Tie
three, equally spaced single knots in Rope
(N64)
. Push the other end of rope through hole in Ramp
and tie a double knot on underside of Ramp. Repeat for the other Rope
(N64)
.
WARNING: To prevent the risk of strangulation, three knots must be tied in ropes and ropes
must be secure at both ends. Ropes must be tight enough that they cannot be
looped back on themselves, and no more than 12" of rope should be left after
tying double knots at the top and bottom of the ropes.
116
Step 67
Ramp Installation