![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621057.webp)
1 11/16"
27 5/16"
INSET C
Continued on next page:
6133
1 11/16"
27 5/16"
6140
1. If one or both of the 2 Hole Facias
(3139)
were not installed in Step 15, a
7/16" DIA. hole
with a
1 1/8" DIA., 3/8" deep counter bore
will have to be drilled in the Deck Runner
(3141) (3203)
, as
shown in Inset B.
*WARNING: If the screws were installed in the center holes of the Short Deck Boards (3140),
in Step 13, they will have to be removed, and discarded prior to drilling Deck
Runner.
*NOTE: Only drill the Deck Runner (3141) (3203) beneath the Center Post if the 2 Hole Facia
has not been installed on that side.
*NOTE: If installing Wood Roof, install Short Center Posts (6140) in place of Center Posts
(6133). If installing Cabin package, refer to Step 60 for Short Center Post (6140)
modification instructions.
2. In one Center Post
(6133) (6140)
drill a
7/16" DIA. hole
with a
1 1/8" DIA. counter bore, 3/8" deep
referring to measurements shown in Inset C.
3. Position Center Post
(6133) (6140)
against back of Accessory Arm
(6134)
and attach through Center
Post using 3/8" Hardware
(H3) (H119)
. Finish attaching Center Post through 2 Hole Facia
(3139)
using 3/8" Hardware
(H3) (H116)
.
*NOTE: Center Post (6133) (6140) will measure 30 5/8" from outside face of Corner Uprights
be flush with end of Corner Facia (3139) when properly installed.
4. Position remaining three Center Posts
(6133) (6140)
against 6 Hole Facias
(4051),
2 Hole Facia
(3143)
and Corner Facias
(3139)
and down on Deck. Attach Center Posts using 3/8" Hardware
(H3) (H116)
.
*NOTE: Center Posts must be flush with ends of 2 Hole Facias (as shown) and measure
30 5/8" from outside faces of Corner Posts, when properly installed.
*NOTE: Center Post (6133) in middle of set will be attach through 6 Hole Facia and through
underside of upper level deck. If installing Wood Roof, the Short Center Post (6140)
will not be installed in middle of set (as shown on next page).
5. Be sure that middle Center Post
(6133)
is plumb and attach through underside of upper level deck
using 3/8" Hardware
(H3) (H119)
(as shown in Inset A).
*NOTE: To help prevent the Center Post (6133) from splitting, predrill through the Deck and
into the Center Posts using a 1/4" drill bit prior to installing 3/8" Hardware (H119).
4. If attaching Center Posts
(6133) (6140)
through deck instead of 2 Hole Facias
(3139)
, ensure
Center Posts
(6133) (6140)
are plumb, and attach through drilled holes in Deck Runner and into
bottoms of Center Post using 3/8" Hardware
(H3) (H119)
using same processes shown in Inset A.
7/16" DIA. HOLE W/ 1 1/8"
DIA. COUNTER BORE; 3/8" DEEP
56
Step 16
Center Post
Installation