![background image](http://html1.mh-extra.com/html/rainbow/turbo-carnival-clubhouse/turbo-carnival-clubhouse_assembly-instructions-manual_3449621120.webp)
A
H3
H11
H125
H226
H34
N384
4051
N381
INSET B
MATCH DRILL
THROUGH
THESE HOLES
19 3/4"
12"
14" DEEP
HOLE
TOP VIEW OF SET
N384
N382
INSET A
B
H3
H116
6134
N381
N384
INSET C
*WARNING: LOCATE ALL UNDERGROUND UTILITIES BEFORE DIGGING.
1. Measure out from set
19 3/4"
, and in from Upright
12"
, and dig a hole approximately
14" deep
for
Fire Pole assembly to sit in (as shown in Top View of Set).
2. Locate Short Fire Pole Extension
(N384)
and thread Extension onto Fire Pole Mid-Section
(N382)
(as
shown in Inset A).
*NOTE: Only one Fire Pole Extension will be used.
3. Insert assembled Extension onto Fire Pole Top
(N381)
and secure to Fire Pole Top using #8
Hardware
(H226)
(as shown in Inset B).
4. Lift assembled Fire Pole up against 6 Hole Facia
(4051)
, center in opening, and match drill through
Fire Pole Top
(N381)
and Facia using a
7/16" drill bit
(as shown in Inset B).
5. Attach Fire Pole assembly to 6 Hole Facia
(4051)
using 3/8" Hardware
(H3) (H11) (H34) (H125)
.
*NOTE: A small hammer or mallet may be needed to pound in 3/8" Hardware (H34).
6. If installing Fire Pole on 60" Deck Height, position Fire Pole against Accessory Arm
(6134)
and
attach using 3/8" Hardware
(H3) (H116)
(as shown in Inset C).
7. Ensure Fire Pole is plumb and fill hole around Fire Pole with concrete.
!
119
Step 71
Fire Pole
Installation