Radwin 5000 HPMP, User Manual

Page: 75 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 5 ‐ 6
Getting Started with the RADWIN Manager
We have add place ‐ holders for a further three nomadic HSUs. That is, up to four vehicles
equipped to work in this way, may operate simultaneously in the sector.

To start the RADWIN Manager:
1. Connect the managing computer to the HBS PoE LAN port.
2. Check that you have connectivity to the HBS. You can do this by opening up a
command line session ( Start|Run and then type, cmd ). At the command prompt,
type
ping 10.104.50.200
You should see something like this:
Table 5 ‐ 5:
Preconfigured setup - one nomadic HSU
Location Attribute Value Remark
HNU.01.01
IPv4
Address 10.104.50.3
All communicating HSUs and HBS in
the same subnet
Net Mask 255.255.0.0
Default Gateway 10.104.10.21
IPv6
Address 2005:104:50::3
Subnet Prefix Length 32
Default Gateway 2005:104:20::21
Protocol SNMPv1 Can be set to SNMPv3 or both v1
Contact Brahms Optional
Name Brahms@HNU.01.01 Location of Contact ‐ optional
Time Slots
Downlink 6
May vary with context
Uplink 2
Unit Serial Number P07030E000A0003B
Tip
Choose your unit locations carefully. For example, for three collocated HBSs
each with 32 HSUs covering 360°, matters get out of hand very quickly if
units are poorly named. They can always be identified by their IP addresses,
but that is a poor substitute for effective naming. A URL ‐ like naming pattern
based on HBS_n.HSU_y is clear and familiar to all Internet users. Keeping
the names IP address independent enables you to copy the entire sector
setup to a different geographic location without IP address duplication.