Radwin 5000 HPMP, User Manual

Page: 121 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 6 ‐ 9
Configuring the Sector out of the Box ‐ IP Addresses
Figure 6 ‐ 1: Logging on with factory default IP address
Alternatively, you can log on using Local Connection without need to change your Network
Interface Card address:
Figure 6 ‐ 2: Logging on with Local Connection
Warning
• The Local Connection method uses broadcast packets to “discover”
the attached ODU
• If you log on using Local Connection , but your physical connection is
not local (i.e. anything other than a direct connection between the
managing computer and the PoE device), then any configuration you
carry out may affect other links in the network. Do not do this!
• Do not carry out this procedure using a multi homed managing com ‐
puter also connected to a network. It will flood the network with
broadcast packets. Further, it will throw any other links on the network
into Installation or Inactive mode.
• In any event, as a precaution, default log ‐ on over Local Connection is
read ‐ only mode. Check the Read/Write enable box to carry out instal ‐
lation procedures.
• Network log on (IP address to the ODU) is recommended.