Radwin 5000 HPMP, User Manual

Page: 482 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 C ‐ 63
Private MIB Parameters
winlink1000IduTdmJitterBufferDefa
ultSize RO TDM Jitter Buffer Default Size. The units are 0.1
x millisecond.
winlink1000IduTdmJitterBufferMinS
ize RO TDM Jitter Buffer Minimum Size. The units are
0.1 x millisecond.
winlink1000IduTdmJitterBufferMax
Size RO TDM Jitter Buffer Maximum Size. The units are
0.1 x millisecond.
winlink1000IduTdmJitterBufferSizeE
val RW TDM Jitter Buffer Size for evaluation. The
value must be between the minimum and the
maximum TDM Jitter Buffer Size. The units are
0.1 x millisecond.
winlink1000IduTdmType RW TDM Type (The value undefined is read ‐ only).
winlink1000IduTdmTypeEval RW TDM Type for evaluation.
winlink1000IduTdmLineStatusStr RO Line status.
winlink1000IduTdmHotStandbySup
port RO Indicates if Hot Standby is supported.
winlink1000IduTdmDesiredHotStan
dbyMode RW Desired Hot Standby Mode.
winlink1000IduTdmHotStandbyOpe
rationStatus RO The Link Actual Status.
winlink1000IduTdmBackupLinkConf
iguration RW The current configuration of the backup link.
winlink1000IduTdmLineInterfaceCo
nfiguration RW TDM Line interface configuration.
winlink1000IduTdmLineImpedance
Configuration RW TDM line impedance configuration (standardT1 ‐
100Ohm nonStandardT1 ‐ 110Ohm)
Applicable only for T1 TDM type.
winlink1000HbsAirState RO Holds the state of the HBS.
winlink1000HbsAirOpMode RW Holds the operation mode of the HBS.
winlink1000HbsAirAvailTimeSlots RO This parameter holds the number of available
time slots (not in use) in the air interface.
winlink1000HbsAirSectorCbwSuppo
rtedStr RO Represents the channel bandwidth which is
supported by the HBS and all connected HSUs.
winlink1000HbsAirCompressedMon RO Holds HBS monitor data in compressed format:
HBS Traffic Monitor In Bytes(4) Out Bytes(4)
In Frames(4) Out Frames(4) HBS State (1) HBS
Freq (4) Number of Links (2) EC Change
Counter (4) Current Ratio (2) Total Air Frames
(4) HBS Rx Rate in Kbps (4) HBS Tx Rate in Kbps
(4) HBS Rx Rate in Fps (4) HBS Tx Rate in Fps
(4) HBS Set Mode (1).
winlink1000HbsAirConfChanges RO 16 characters that represent 16 HSUs. Each
time a configuration is been changed increment
the relevant character.
winlink1000HbsAirConfTable N/A Holds the table for all registered HSUs in the
sector (16 entries).
winlink1000HbsAirConfEntry N/A HSUs configuration table entry. INDEX {
winlink1000HbsAirConfIndex }
winlink1000HbsAirConfIndex RO HSUs configuration table index.
winlink1000HbsAirConfUpMir RW Uplink MIR towards specific HSU in units of
kbps.
winlink1000HbsAirConfDownMir RW Downlink MIR towards specific HSU in units of
kbps.
winlink1000HbsAirConfHsuName RW HSU name.
winlink1000HbsAirConfHsuLocation RW HSU location.
Table C ‐ 3: Private MIB Parameters ‐ HSU (Sheet 25 of 33)
Name OID Type
A
cce
ss
Description