Radwin 5000 HPMP, User Manual

Page: 446 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 C ‐ 27
Private MIB Parameters
winlink1000IduSrvAvailableTrunks RO A bitmap describing the number of TDM trunks
that can be opened in the current configuration.
The values take into account the IDU hardware
configuration the air rate and the installation
range.
winlink1000IduSrvPossibleServices
Table N/A IDU Possible Services table.
winlink1000IduSrvPossibleServices
Entry N/A IDU Services table entry. INDEX {
winlink1000IduSrvPossibleServicesIndex }
winlink1000IduSrvPossibleServicesI
ndex RO Table index Rate index of the air interface.
winlink1000IduSrvPossibleTdmServi
ces RO Deprecated parameter. A bitmap describing the
TDM trunks that can be opened in the
corresponding Air Rate.
winlink1000IduSrvPossibleEthServic
es RO Deprecated parameter. This parameter
describes if the Ethernet Service can be opened
in the corresponding Air Rate. The valid values
are: disabled (0) enabled (1).
winlink1000IduSrvRemainingRate RO Current Ethernet bandwidth in bps per air rate.
winlink1000IduSrvTrunkCost RO Cost of the TDM Service in bps.
winlink1000IduSrvAvailServicesTabl
e N/A ODU Possible TDM Services table.
winlink1000IduSrvAvailServicesEntr
y N/A ODU TDM Services table entry. INDEX {
winlink1000IduSrvAvailServicesIndex }
winlink1000IduSrvAvailServicesInde
x RO Table index. The index is the bit mask of the
TDM service.
winlink1000IduSrvAvailServicesStat
e RO Represents the TDM service availability.
winlink1000IduSrvAvailServicesMin
RateIdx RO Minimum rate index of the air interface which
make the service possible.
winlink1000IduSrvAvailServicesMax
RateIdx RO Maximum rate index of the air interface which
make the service possible.
winlink1000IduSrvAvailServicesRea
son RO Information about the TDM Service availability.
‐ Not Applicable if the service is available. The
reasons for TDM Service unavailability: ‐ The
available throughput isn't sufficient for Service
demands; ‐ The IDU HW doesn't support the
service; ‐ A Link Password mismatch was
detected; ‐ The external pulse type detected is
improper for TDM services; ‐ A Software
versions mismatch was detected. ‐ A ‐ Symetric
TDD Mode Is Obligated.
winlink1000IduSrvEthActive RO Represents the Ethernet service activation state.
winlink1000IduSrvEthAvailable RO Represents the Ethernet service availability
state.
winlink1000IduSrvEthThroughput RO Current available Ethernet service throughput in
bps.
winlink1000IduSrvEthMaxInfoRate RW Holds the maximum bandwidth (kbps) to be
allocated for Ethernet service. Value of zero
means that Ethernet service works as best
effort. The maximum value is product specific.
Refer to the user manual.
winlink1000IduSrvAvailableTrunksT
1 RO A bitmap describing the TDM trunks that can be
opened under T1 configuration. The values
take into account the IDU hardware
configuration the air rate and the installation
range.
Table C ‐ 2: Private MIB Parameters ‐ HBS (Sheet 22 of 33)
Name OID Type
A
cce
ss
Description